Welcome to the VanDyke Software Forums

Join the discussion today!


Go Back   VanDyke Software Forums > General

Reply
 
Thread Tools Display Modes
  #1  
Old 09-09-2012, 05:56 PM
davinman davinman is offline
Registered User
 
Join Date: May 2007
Posts: 9
^@ every 20secs on terminal

When I am connected to a router console via telnet using securcrt 7.0.0 build326 I get ^@ about every 20 secs. If I use the Mac Terminal window and telnet to the same device I do not get the ^@. There is also a bell but I was able to disable that in the session options.


Thanks,
David Inman
Reply With Quote
  #2  
Old 09-10-2012, 11:45 AM
rtb rtb is offline
VanDyke Technical Support
 
Join Date: Aug 2008
Posts: 4,306
Hi David,

My guess is that you have configured your session to send something to the remote on a regular basis. Do you have either of the Anti-idle options enabled in the Terminal category of the Session Options dialog which are set to a 20 second interval?
__________________
--Todd

VanDyke Software
Technical Support
support@vandyke.com
505-332-5730
Reply With Quote
  #3  
Old 09-11-2012, 10:01 AM
davinman davinman is offline
Registered User
 
Join Date: May 2007
Posts: 9
send no-op is checked "currently greyed out" but it is set to every 60sec
Reply With Quote
  #4  
Old 09-11-2012, 10:30 AM
rtb rtb is offline
VanDyke Technical Support
 
Join Date: Aug 2008
Posts: 4,306
Hi David,

Thanks for the information. Would you send a raw log of a connection where you see the issue to support@vandyke.com with a subject of Attn: Todd - Forum thread #10664?

Here is how you can create a raw log:
  1. Before connecting with the session, select Raw Log Session from SecureCRT's File menu.
  2. In the Select Log File dialog, choose a folder and filename in which you would like the log text to be stored and click the Save button. At this point, if you open the File menu, you will notice that Raw Log Session now has a check-mark next to it; this indicates that raw logging is activated.
  3. Now connect to the remote machine and perform the actions which cause the reported problem to occur.
  4. Disconnect the session and select Raw Log Session from the File menu to turn off the raw log feature.
  5. Browse to the location of the raw log file and attach it to your message.
__________________
--Todd

VanDyke Software
Technical Support
support@vandyke.com
505-332-5730
Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 10:59 AM.