View Single Post
  #36  
Old 10-13-2014, 11:51 PM
kgaudineer kgaudineer is offline
Registered User
 
Join Date: Jan 2011
Posts: 15
Good evening rtb,

following the first command copy startup-config tftp the Cisco switch will respond with:
Address or name of remote host []?
The IP address 10.24.21.117 needs to be manually entered or in this case its just a separate line in my commands file that is read.
After entering the IP address press enter
The switch responds with:
Destination filename [Cisco-2960-confg]?
The switch will automatically use its host name as the config file name. For us this is just fine so there is no need to change anything and we just press the enter key to accept the name as it is shown.
Reply With Quote