View Single Post
  #1  
Old 08-01-2018, 10:22 PM
cekoj cekoj is offline
Registered User
 
Join Date: Jul 2018
Posts: 3
Post Get specific values from a table

Support me with some problem that i have. We are performed an audit logs but, is there a form to get some specific values in a table?

We have detected 2 different tables as below:
Code:
TABLE 1:
====================================================================================================================================
FRU    LNH    BOARD       ST FAULT OPER MAINT STAT PRODUCTNUMBER   REV     SERIAL        DATE      TEMP
=====================================================================================================================================
BB-1   000100 DUS5301      1   OFF   ON   OFF   ON KDU137848/11    R2B     B441317340    20180407        (Bb6630)
Code:
TABLE 2:
SMN APN  BOARD    FAULT  OPER   MAINT  STAT    PRODUCTNUMBER  REV    SERIAL     DATE     TEMP COREMGR
====================================================================================================================
  0   1  DUW4101  OFF    ON     OFF    OFF     KDU127174/4    R2F    TU8XAW5590 20160726 68C  Active*
--------------------------------------------------------------------------------------------------------------------
The problem is that I want to get PRODUCTNUMBER, REV, SERIAL and DATE. As you see, values are not separate with a constant spaces.

Please, if you can give me an advice or support, provide your feedback.

Last edited by jdev; 08-06-2018 at 10:20 AM.
Reply With Quote